电动升降平台蓄电池故障的原因及解决方法？

电动升降平台蓄电池故障的原因及解决方法？

With the development of industry, elevator equipment has also been widely used by users.

In the daily life of using elevators, it is inevitable that elevators will fail. The following is a detailed.

explanation of the causes and troubleshooting methods of the failures in the use of the elevator:

随着工业的发展，电梯设备也得到了用户的广泛应用。在使用电梯的日常生活中，电梯出现故障是不可避免的。

Reasons and troubleshooting methods for the table top to slide after the lift rises:

升降机上升后桌面滑动的原因和故障排除方法：

First, the normally closed valve or the one-way valve of the hydraulic pump station is too dirty, causing the table to slide down.

Under the guidance of technicians, you can remove the normally closed valve or the one-way valve by yourself, and use the cleaning agent for cleaning.

If the problem is not resolved, replace with a new one-way valve or normally closed valve.

首先，液压泵站的常闭阀或单向阀太脏，导致工作台滑落。在技术人员的指导下，可自行拆下常闭阀或单向阀，使用清洗剂进行清洗。如果问题没有解决，请更换新的单向阀或常闭阀。

Second, there will be a power outage during use, and the equipment will be dropped to the ground through the emergency bolts on the equipment.

After the call, because the emergency bolts were not tightened at that time, the equipment was lifted and the background surface fell.

Check whether the emergency bolt is tightened, and find that it is not tightened, tighten the emergency bolt to eliminate the fault.

其次，使用过程中会出现停电，设备会通过设备上的应急螺栓掉落到地面。通话后，由于当时没有拧紧紧急螺栓，设备被抬起，背景面掉落。

检查应急螺栓是否拧紧，发现没有拧紧，拧紧应急螺栓以排除故障。

Third, oil leakage from the oil pipes or cylinders of the elevator will cause the equipment to be lifted back down.

Contact the manufacturer to replace the oil pipe and the sealing ring in the cylinder.

第三，电梯油管或油缸漏油会导致设备被抬回。联系制造商更换油缸中的油管和密封圈。

Reasons and troubleshooting methods for the speed of the elevator being too fast or too slow during the descending process:

电梯下降过程中速度过快或过慢的原因及排除方法：

The inaccurate adjustment of the descending speed control valve on the new hydraulic pump station caused the descending speed to be too fast or too slow.

Adjust the descending speed control valve according to your own use conditions to meet the needs of your own production operations.

新液压泵站下降速度控制阀调整不准确，导致下降速度过快或过慢。根据自己的使用条件调整降速控制阀，满足自己生产操作的需要。